How to
How to make a spur gear
This gear generator draws involute spur gears, the tooth shape used in almost every real gearbox, from the number of teeth and the module. Add a second gear and it is placed at the exact center distance, meshing with the first. Download a cut-ready SVG for a laser cutter or a vinyl cutter, a DXF for CAD and CNC, or a PNG for documentation.
- Choose the teeth. The ratio between two gears is the ratio of their teeth: 24 and 12 teeth give 2:1.
- Set the tooth size. Pick a module in millimeters, or a diametral pitch for inch gears. Gears that run together must share it.
- Add a bore and backlash. The bore fits your shaft or bearing. Backlash leaves a little play so the teeth do not bind.
- Export. Download cut SVG gives outlines only, at true size in millimeters. Download DXF uses the units you chose under Dimensions.
What the sizes mean
The pitch diameter is the circle where two gears roll on each other without slipping; it equals module times teeth. The outside diameter adds one module on each side for the tooth tips, and the root diameter is 1.25 modules smaller on each side, leaving clearance under the tips of the other gear. The base circle is where the involute curve of each tooth starts. All four are listed under Dimensions and update as you type.
Laser cutting and 3D printing
For a laser, cut a test pair first: the beam removes a thin kerf, so cut gears come out slightly smaller and looser. Plywood and acrylic gears work well from module 2 up; smaller teeth char and break. For 3D printing, import the SVG into your CAD tool and extrude it, or use the SVG to STL converter to get a printable gear in one step. The SVG to DXF converter handles any other part you draw around it.
Choosing a ratio
Avoid ratios where one tooth count divides the other exactly, like 12 and 24, for gears that wear in: the same teeth meet every turn. 12 and 25 spread the wear across all teeth with almost the same ratio.
Questions people ask
How do I make a gear SVG for laser cutting?
Set the number of teeth and the module, add a bore for the shaft, then choose Download cut SVG. That file holds only outlines, sized in millimeters, so LightBurn, Glowforge, xTool and Cricut import it at true size. For CAD or CNC software, Download DXF gives the same outlines in millimeters or inches.
What is the module of a gear?
The module is the size of the teeth in millimeters: the pitch diameter divided by the number of teeth. A 24 tooth gear with module 2 has a pitch diameter of 48 mm. Two gears only mesh when their module and pressure angle match. Inch gears use diametral pitch instead, which is 25.4 divided by the module.
Which pressure angle should I choose?
Use 20 degrees unless you are matching an existing gear. It is the modern standard for spur gears, strong at the root and smooth running. 14.5 degrees appears on older machinery and some inch gears, and 25 degrees gives thicker, stronger teeth for heavy loads. Both gears in a pair must use the same angle.
How do I work out the center distance between two gears?
Add the two pitch diameters and divide by two, which is the same as the module times the total number of teeth, divided by two. Module 2 with 24 and 12 teeth gives 2 × 36 ÷ 2 = 36 mm. The generator shows this distance and places the second gear there, so the preview shows the pair exactly as it will mesh.
Why add backlash to a gear?
Backlash is a small gap between meshing teeth. Without it, laser kerf, 3D printing tolerances and swelling in wood or plastic make the teeth bind. The value here thins each tooth at the pitch circle by the amount you enter, shared between both sides. For laser cut plywood and 3D prints, 0.1 to 0.2 mm is a good start.